Laptop installation answer/timing issues
Leisha Wharfield
leisha at decisionresearch.org
Tue Mar 7 00:17:12 UTC 2006
Hi, all,
Thanks for your helpful replies on installing Eprime on new laptops. I
had to go to the Eprime staff for the answer to laptop
installation--apparently our problem was attempting to install to a
newer computer from our original CD. We needed to download the
installation file from the web site & use that instead. Also the
hardware key is left off until the installation application requests it.
Next issue: Found some problems with the critical timing when I ran
Eprime's RefreshClockTest. My little laptop didn't pass the test until I
unplugged it from the network. That's all good, but I get the screen
that says the test is running for 640 x 480 pixels & 16-bit color, and
that if my settings don't match I should change them in that utility,
then run the RefreshClockTest again.
My question: How much does this matter? I can't see how to change the
display settings within that utility--which I'm assuming means the
RefreshClockTest.es. I'll keep looking for how to do this.
Alternatively, I could match my laptop's display settings to those of
the RefreshClockTest, but those are not the settings we will use for
running experiments and I don't have 460 x 480 as an option. Lowest
resolution on the laptop screen is 800 x 600.
How much does this matter? Should I go with my positive result & move
ahead with longer testing times, or sync up these display settings first?
Thanks much for any thoughts on this,
Leisha Wharfield
Decision Research
Eugene, Oregon, USA
More information about the Eprime
mailing list