reading data from biopac

[Joe]

Hi all,

I am a new member to this group and this is my first post.  I am a
student at Saginaw Valley and recently started a job in the psychology
department as a computer lab tech.  My boss wants me to start playing
around with biopac and to design a program in e-prime that will record
the readings from the biopac system in addition to all the usual e-
prime data logging.  I have the computer running e-prime connected to
the biopac hardware via a standard 25 pin d-sub cable.  However, no
matter what I do, I cannot get the e-prime program to record any
data.  I used the readport function and tried several ports in case I
had mistakenly used the wrong base address.  However, the data was
always the same for each trial.  One base address gave me all readouts
of 120, another all 255, etc...  None of them actually transmitted any
useful data.

I looked through the archives of old posts in this group and found a
similar case that provided some suggestions.  The problem is that some
of these suggestions involved changing bios settings for the port and
before I go that route (Jumping through hoops to get IT to allow us to
access the system), I wanted to know if the problem was resolved using
that method or if not, what might be a better option?

I appreciate any help anyone has to offer,

Joe
--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "E-Prime" group.
To post to this group, send email to e-prime at googlegroups.com
To unsubscribe from this group, send email to e-prime+unsubscribe at googlegroups.com
For more options, visit this group at http://groups.google.com/group/e-prime?hl=en
-~----------~----~----~----~------~----~------~--~---